April 07, 2015 Volume 11 Issue 13

Designfax weekly eMagazine

Subscribe Today!
image of Designfax newsletter


View Archives


Manufacturing Center
Product Spotlight

Modern Applications News
Metalworking Ideas For
Today's Job Shops

Tooling and Production
Strategies for large
metalworking plants

Engineer's Toolbox:
NASA conducts successful test flights for Mars find-by-sight landing technology

The ADAPT test system can help a spacecraft divert its course and make a smooth, pinpoint landing. The system is built on Masten's XA-0.1B "Xombie" vertical-launch, vertical-landing reusable rocket. [Credit: NASA Photo/Tom Tschida]





It's tricky to get a spacecraft to land exactly where you want. That's why the area where the Mars rover Curiosity team had targeted to land was an ellipse that may seem large, measuring 12 miles by 4 miles (20 km by 7 km).

Engineers at NASA's Jet Propulsion Laboratory in Pasadena, CA, have been developing cutting-edge technologies that would enable spacecraft to land at a specific location on Mars -- or any other planetary body -- with more precision than ever before. In collaboration with Masten Space Systems in Mojave, CA, they have recently tested these technologies on board a high-tech demonstration vehicle called the Autonomous Descent and Ascent Powered-flight Testbed (ADAPT).

ADAPT is a test system built on Masten's XA-0.1B "Xombie" vertical-launch, vertical-landing reusable rocket. The Xombie platform provides a good approximation of Mars-like descent conditions through high-speed descent rates at low altitudes. Those conditions are difficult to achieve through conventional flight test platforms. Onboard this rocket, two sophisticated lander technologies were recently tested: Terrain Relative Navigation with a sensor called the Lander Vision System (LVS), and the Guidance for Fuel-Optimal Large Diverts (G-FOLD) algorithm.

"No previous Mars lander has used onboard surface imaging to achieve a safe and precise touchdown, but a future spacecraft could use LVS and G-FOLD to first autonomously determine its location and then optimally fly to its intended landing site," said Nikolas Trawny, ADAPT's principal investigator at JPL. "All of this happens on board, without human intervention, and in real time."

ADAPT had two successful test flights, one on Dec. 4, 2014, and the second on Dec. 9, 2014. In both cases, the rocket reached a maximum altitude of 1,066 ft (325 m) before beginning its descent.

On Dec. 9, 2014, the Xombie rocket carrying the ADAPT system reached a maximum altitude of 1,066 ft (325 m) before beginning its descent. [Credit: NASA Photo/Tom Tschida]



The terrain-relative navigation capability provided by LVS allows Xombie to precisely determine its position without requiring GPS. To do so, ADAPT first takes a series of pictures of the terrain below it during descent. These pictures are then compared to an image of the terrain stored onboard, allowing the vehicle to autonomously find its position relative to the landing site. The spacecraft can then use this information to correct its course to get as close to the targeted landing site as possible within its capability, and make a smooth, pinpoint landing.

G-FOLD is an algorithm, developed at JPL and at the University of Texas at Austin, that calculates the optimal path to divert a spacecraft to a target landing site in real time. For the first time, G-FOLD allows onboard calculation of divert trajectories that obtain the maximum performance from every kilogram of propellant.

The ADAPT technology has numerous potential applications, including landing on the moon, asteroids, and other space targets of interest. [Credit: NASA Photo/Tom Tschida]



The combination of LVS and G-FOLD allowed the Xombie rocket to begin to change the course of its descent at about 623 ft (190 m) in the air on Dec. 9. The rocket then flew the newly calculated course to successfully reach the target landing pad located 984 ft (300 m) to the east.

"This represents a huge step forward in our future capabilities for safe and precise Mars landing, and demonstrates a highly effective approach for rapid, low-cost validation of new technologies for the entry, descent and landing of spacecraft," said Chad Edwards, chief technologist of the Mars Exploration Directorate at JPL. "This same technology has valuable applications to landing on the moon, asteroids, and other space targets of interest."

NASA's Space Technology Mission Directorate is facilitating the tests via its Flight Opportunities Program managed at NASA's Armstrong Flight Research Center at Edwards Air Force Base, CA.

JPL, a division of the California Institute of Technology, Pasadena, manages the ADAPT project and funded the ADAPT payload development. The LVS prototype was designed, developed, and tested by the Mars Technology Development program of NASA's Science Mission Directorate.

Source: NASA Jet Propulsion Laboratory in Pasadena, CA

Published April 2015

Rate this article

[Engineer's Toolbox:
NASA conducts successful test flights for Mars find-by-sight landing technology]

Very interesting, with information I can use
Interesting, with information I may use
Interesting, but not applicable to my operation
Not interesting or inaccurate

E-mail Address (required):


Type the number:

Copyright © 2015 by Nelson Publishing, Inc. All rights reserved. Reproduction Prohibited.
View our terms of use and privacy policy