Designfax weekly eMagazine

Subscribe Today!

Archives

View Archives

Partners

Manufacturing Center
Product Spotlight

Modern Applications News
Metalworking Ideas For
Today's Job Shops

Tooling and Production
Strategies for large
metalworking plants

3D-printed wood is made from its own natural components

Researchers at Rice University have unlocked the potential to use 3D printing to make sustainable wood structures, offering a greener alternative to traditional manufacturing methods.

Wood has historically been marred by wasteful practices generated during shaping processes, driving up costs and environmental impact. Now, researchers in materials science and nanoengineering at Rice have developed an additive-free, water-based ink made of lignin and cellulose, the fundamental building blocks of wood. The ink can be used to produce architecturally intricate wood structures via a 3D-printing technique known as direct ink writing.

The work was recently published in the journal Science Advances.

Muhammad Rahman (center), an assistant research professor of materials science and nanoengineering at Rice University, is shown with fellow researchers M.S.H Thakur (left) and Chen Shi (right) in Rahman's lab. [Credit: Photo courtesy of Gustavo Raskosky/Rice University]

 

 

 

 

"The ability to create a wood structure directly from its own natural components sets the stage for a more eco-friendly and innovative future," said Muhammad Rahman, an assistant research professor of materials science and nanoengineering at Rice. "It heralds a new era of sustainable, 3D-printed wood construction."

The implications are far reaching, potentially enhancing industries such as furniture and construction.

"Unlike previous attempts, this method exclusively uses nanoscale wood components for 3D printing, marking a significant advancement in the field," said Pulickel Ajayan, the Benjamin M. and Mary Greenwood Anderson Professor in Engineering and professor and chair of materials science and nanoengineering at Rice.

The university's research focused on optimizing the composition of the ink by adjusting the ratio of lignin, cellulose nanofibers, and nanocrystals while maintaining the natural lignin-cellulose balance, according to both M.S.H Thakur and Chen Shi, lead co-authors on the study.

Researchers at Rice University have unlocked the potential to use 3D printing to make wooden objects. [Credit: Photo courtesy of Gustavo Raskosky/Rice University]

 

 

Although lignin is one of the most abundant biopolymers on Earth, it is the least-valued product in industries, noted Amit Naskar, a project collaborator and senior research and development staff at Oak Ridge National Laboratory.

Post-printing, comprehensive analyses were conducted to assess the surface and internal structures of the 3D-printed wood, comparing it to natural wood counterparts. The payoff not only exhibited close similarities to natural wood in texture but also in scent and strength.

Additionally, mechanical tests were performed to evaluate compressive and bending strengths, revealing promising results that surpassed those of natural balsa wood.

The research was supported by Rice and the Rice Shared Equipment Authority and the U.S. Department of Energy's Office of Science, Basic Energy Sciences and Engineering Division.

Designfax Editor's Note: Did you know there is a 3D-pritable wood material available using Desktop Metal's binder jetting 3D-printing technology? Check out Forust technology -- made from sawdust and lignin -- at https://proto3000.com/product/forust/.

Source: Rice University

Published May 2024

Rate this article